1. Use existing standard bearer or pike man with bear flag pole, or
2. Cut off cast-on flag then grind down / file pole using “Dremel “ type router.
3.  Prepare paper flag around wire template with diameter slightly less than pole/pike. This ensures that final push fit is snug. Use “Pritt Stick” when gluing sides of flags together. Form folds, gently crease against wire & remove from former before glue dries.
4. Super glue in point made from flattened & shaped brass tube; this only needs to extend into paper flag by about 5mm to ensure that most of the hollow is available to slip over pole/pike, as illustrated.

NB: push fit of the final product enables flags to be swapped on a temporary basis (best varnish the flag if you anticipate frequent handling). Alternatively it super-glued to the pole for permanent fix.

This is my new – more simple – system for making standard bearers without  having to drill the pike/pole to take thin wire. However, if the figure does not have a cast on pole then this system still works if you pre-fix one make from plain wire or brass tube.

Ray Boyles. August 2013